Advertisement
Installation Instructions:
1.
Position the MegaLoop DAC™ amplifier on shelf under TV or
beside the TV.
Plug the MegaLoop DAC™ mains power adapter (B) into a
2.
standard electrical power socket, then plug the power lead
into socket1(Fig. 2).
Starting from the amplifier, run the loop wire (C) around the
3.
edge of the room. The wire can be tacked up and over door
frames if necessary. The wire can be tucked under the carpet
or clipped to the skirting board (Fig. 3). Make sure you leave
enough wire to reach the amplifier.
4.
Once a complete loop of the room has been formed, cut
away any surplus wire making sure to cut away the insulation
from the wire ends. Clip each end of the wire into terminals (2)
(Fig. 2).
If you are using a loop pad (Optional), clip the end of the lead
5.
into terminals (2) (Fig. 2). Make sure the lead is placed
carefully, so as not to cause a tripping hazard. Never run
the lead across the floor unless fully under the carpet.
Always remember that loose wires are a tripping hazard.
6.
When connecting to a TV which has digital optical audio
output (see page 8/ 9 ) use the Toslink cable (H) to connect
from the TV digital output socket to the MegaLoop DAC™
digital socket (4) (Fig. 2).
*NOTE if no sound signal is going into the MegaLoop DAC™
the no signal LED (5) (Fig. 2) will be illuminated.
7.
When connecting to a TV that has analogue audio output
sockets (see page 8) connect the lead (G) to the phono audio
output sockets on the TV and connect the other end to the
line socket (6) (Fig 2).
5
Advertisement
