Lascal BUGGYBOARD MAXI+ Owner's Manual page 7

7.
Alt. A
8.
B
1
2
3
7. Positioning the cotter pins
Measure the distance between the middle of
each of the connectors.
Deciding the cotter pin direction
If the measured distance is between:
• 25-40 cm (10-16 in.)
• 40-50 cm (16-20 in.)
Alt. B
8. Choosing the correct hole
There are three holes in each arm. To choose
the hole which best suits your stroller, mount
A
the BuggyBoard as close as possible to your
stroller but also make sure your child can
stand comfortably.
Once decided, screw the cotter pin into your
chosen hole, tighten with a coin.
If the arms are too short to fit your stroller,
there is an "Extender Kit" available as an
accessory, see fig 13.
- 7 -
ð
Alt. A below.
ð
Alt. B below.