Power Off - Circuit Specialists TC-V2.12k User Manual

2.6 IR decoder
After the component detection is completed, the infrared remote control at the tester "IR" test
hole, press the remote control key, the tester will be display the user code & data code and the
corresponding infrared waveform after the successful decoding.
If decoding failure, the tester cannot display the user code and data code.
The dot at the top right corner to indicate whether it has received the remote control infrared
data, red represents infrared data is being received, blue represents decoding success.
Information：The IR decoder only support Hitachi IR format.
2.7

Power off

The Multifunction Tester with automatic shutdown and manual shutdown.
Automatic shutdown
When the component detection completed or IR decoding completed and after reaching
the automatically shut down time, the tester automatically shut down.
Automatic shutdown time can be set by the hardware jumpers, timeout support for 10s,
15s, 20s and 25s. Factory set to 20s.
2017-4-62015-8-8
版权所有，侵权必究 All rights reserved 第 22 页,共 25 页 Page 22 , Total25
多功能测试仪（TC-V2.12k）
Multi-function Tester (TC-V2.12k)