Toro 51830 Operator's Manual page 7

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Note:
The battery pack is not fully charged when you
purchase it. Before using the tool for the first time,
refer to Charging the Battery Pack (page
1
Mounting the Battery
Charger (Optional)
Parts needed for this procedure:
2 Screws (not included)
Procedure
If desired, mount the battery charger securely on a
wall using the wall-mount key holes on the back of
the charger.
Mount it indoors (such as a garage or other dry place),
near a power outlet, and out of the reach of children.
Refer to Figure 1 for assistance in mounting the
charger.
Slide the charger over the appropriately positioned
hardware to secure the charger in place (hardware
not included).
Description
Screws (not included)
Allen wrench
Auxiliary handle assembly
Guard
12).
Qty.
2 Mount the battery charger (optional).
1 Unfold the handle.
1 Install the auxiliary handle.
1 Install the guard.
7
Use
Figure 1
g247359