Attach the supplied core to the power cord.
Attach the core as
close to the holder
as possible.
Connect the connector to the power terminal on the rear of the printer.
Put the tab of the holder into the hole of the printer.
Hole (of the printer)
Tab (of the holder)
Attach the supplied cover to the printer securely using the supplied screw for
securing the cover.
Check that the power cord is installed properly.
1. Install the thermal paper. (See the operation manual.)
2. Supply 24V DC from the power supply.
3. Check that all the segments of the indicator on the front panel illuminate and then the
indicator displays " ".
4. Hold down the
1. Open the core.
Core
button for one second or longer to check that the power turns off.
2. Wind the power cord
two turns on the core.
Power terminal
Cover
5
3. Close the core.
Screw for
securing the
cover