In order for us to help you efficiently in case of an accident (with a repair, a warranty case or a general service) you should register your bike. This way, you also X-12 through axle automatically extend the warranty of your Liteville to 10 years. Bottom bracket / crankset Drivetrain...
Liteville Bicycle user manual cartridge of the RockShox Deluxe RT3 damper 1pcs. polish pad WorksFinish frames There is no restrictions for your Liteville 301 Mk15 is 325 PSI (approx. 22 bar). Please use suitable 1pcs. cable inlet closed frame as to the maximum rider weight or the damper air pumps only.
Picture shows Boost SRAM At the chain stay, the 301 Mk15 leaves a clearance of about 77 mm, which results in the following tire width recommendations: •...
11. Shift cable housing 14. Seatpost reduction shims 16. Headset The Liteville 301 Mk15 frame is designed for one- Use nothing but shift cable housings with an outer Using reduction shims, the minimum insert The Liteville 301 Mk15 features the Syntace and two-speed drivetrains.
C. ASSEMBLY 2. Seatpost / seat 3. Headset / fork Headset assembly for 27.5" wheels: The 301 Mk15 is designed for variable seatposts In the first step, ( ), are assembled with internal cable routing. The assembly is sim- to be one single part (refer to picture) plified thanks to the ServicePort at the lower end 1.
The • You may now take the ServicePort out of the lever to brake apart and additionally protects Liteville 301 Mk15 is compatible with front frame. Front derailleur (side swing) the thin walls of your handlebar.
9. Cable routing front derailleur 10. Cable routing rear derailleur • Guide the cable housing from the top right- The housing of the rear derailleur has been hand opening into the down tube and all the inserted into the frame already. way down to the ServicePort.
12. brake hose routing 13. Variable seatpost Guiding the brake hose through the frame, it is The 301 Mk15 is designed for a fully integrated advisable to use a RockShox Barb Connector (see Eightpins variable seatpost. Refer to the separate...
ADVICE for your damper system setup: precisely in order to fit the Eightpins dropper post exactly. It must therefore not be worked The Liteville 301 Mk15 features an interface for if you want your 140 mm All Mountain 301 on or changed in any way.
3M stickers. It is your choice if you put them The screws in your frame are all made from The Liteville WorksFinish is a genuine raw Alu- on your frame or if you do not. Titanium or Aluminum and are produced minum surface, free of any kind of protection 1.
Page 12
The screw needs to be secured again. Unscrew it, clean it and reassemble everything with screwlock. We have summed up a “Screwlock Basics” at www.liteville.de - FAQ. 1 Nm 1 Nm...