Table of Contents
Advertisement
Wiring Connections'
Wiring
At The
NOTE: Use
color-coded wires for the power connections; it is recommended that the
Control
Panel
yositive connection be red and the negative connection be black.
Recommended
Wiring
At The
7720V2
w
If the auxiliary voltage at the control is between 9.5-14.8 volts and can supply 100mA
continuous & 275mA peak, then that output may be used for charging the radio's
battery.
1. Connect the negative wire to the system negative point, which is also the negative
line from the battery.
2.
Run the alarm and power wires to the transmitter location.
NOT
E:
If other peripherals are added to the control, make sure the auxiliary
charging capability is calculated and verified with all peripherals at full peak
current draw. Failure to do so will result in battery failure.
The alarm and power wires can be brought into the transmitter through the base, or
through the cover. If they are to be brought through the cover, cut out the optional wire
entry port.
1. Connect the positive and negative power wires to TB 1-1 and TB 1-2, respectively.
2.
Install the battery into the battery holder, but do not plug in the battery cable yet.
Maximum
Wire
Run
Lengths
Gauge
Distance
300
feet
;:
200
feet
22
125 feet
LEDs and JUMPERS
T
~~~~~lGRNDlu~~~lusEDl
4
I 3
I 2
I 1
IINPUTI OuTpuT
NOT ZONEZONEZONE
ZONE
TEST
RADIO
FAULT
112131415161718
19
I1OII1
'r
T"'rl''r'r'r-r
'r
PANEL'S
PANEL
ZONE INPUTS FROM CONTROL
FOR
TO DIALER OR
AUX POWER
GROUND OR
INITIATING A
LOCAL RADIO
OR '+" TERM.
'-" TERMINAL
TEST MESSAGE
FAULT INDICATOR
OF 7720V2TR
OF 7720V2TR
CYCLE (APPLY
POWER-PACK
POWER-PACK
VOLTAGE TRIGGER)
-BAITERY(12V)
—7720V2
WIRING
CONNECTION
TERMINALS—
Mounting
the
1.
7720V2
2.
Determine the best antenna location for strong radio communication
with the
Master Station network using the 7915 or 7715 FAST Tool (see ANTENNA
MOUNTING section that follows this section).
Mount the 7720V2 to a horizontal or vertical surtace, depending on the antenna
used. Be sure to allow access to the programming port when mounting.
The 7720V2 is intended to be mounted to a horizontal surface, preferably on a
ceiling, or in an attic location on top of a joist when using the supplied wire antenna.
If using the 7720ANT antenna kit, the 7720V2 can be mounted to a vertical surface
such as a wall or beam.
-6-
Advertisement
Table of Contents
