Table of Contents
Advertisement
Exiting Program Mode, Setting Defaults & Assigning Passwords
When the last question is answered, all entries are validated by the system. If no errors
are found, the following is displayed:
~
To review the programming
options
(to ensure that the _
correct
responses
have
been
made),
press
Y. The
programming questions will be displayed again, starting with
question 1. Use the UP/DOWN arrow keys to scroll through the
program fields without changing any of the values. If a value
requires change, simply type in the correct value. When the
last field is displayed, the REVIEW? question again appears.
If errors are found during the validation routine (values are out
of range or there is a conflict of parameters), the REVIEW?
question is replaced by the following:
-
Upon hitting any key, the first invalid entry is displayed. Correct
the entry then press
ENTER
to display the next invalid entry.
When the last invalid entry is corrected, the system again
performs a validation
routine. If no errors are found, the
REVIEW? question is displayed.
To display all program entries (not only invalid entries) press the
up arrow key. The previous question appears. Use the down
arrow key to display subsequent programming entries.
Setting
Factory
Defaults: The programming options can be globally reset to their
factory default values by pressing ESC at the REVIEW? prompt. A confirmation prompt
will appear. Press Y to reset, or press N to return to the REVIEW? prompt. If Y is
pressed, all programmed values will be reset to their original factory settings.
To
exit
program
mode
& assign
passwords,
press N in response to the
REVIEW? question. If no password has been assigned, the following appears:
SEPEl
Passwords can be used to split the programming questions
into two menus. See PASSWORD PROTECTION paragraph ~
earlier in this section. If a password is desired, press Y. The
following prompts appear. Press N if no passwords are
desired.
~~
Enter 1 or 2 depending on the menu to which a password is to be assigned. When
prompted,'enter the desired password (up to 4-digits max.) . You will then be prompted
to reenter it (as confirmation).
NOTE: If using a terminal to program passwords, use only those characters available on
the 7720P to allow later access using a 7720P (A, B, C, D, E, F, S, T, X).
If a password has already been assigned for the current programming
menu, the
ENTER PASSWORD? prompt is replaced by the following:
n
Press Y or N, depending on whether you want to change the
password for the
current
programming menu. If [Y]es, you
will be prompted to enter the new password
twice (as
confirmation). To clear an existing password, answer "Y" to
the "change password" prompt, but press only the ENTER
key when prompted
for the new password
and
its
confirmation.
When the password question(s) have been answered, the system exits program mode
and returns to normal mode. The Programming Tool can then be disconnected, or can
be used to trigger test messages. Refer to the TESTING THE 7720V2 section.
-16-
Advertisement
Table of Contents
