Lehle PARALLEL SW II Operating Instructions Manual page 16

4. Connect the output of your effects unit
to the Return socket (5) of the LEHLE PAR-
ALLEL SW II.
5. Use the Send (9) and Return (11) con-
trollers of the LEHLE PARALLEL SW II to
fine-tune the level of the effects unit con-
nected.
6. Select the desired effect level using the
MIX controller (10) on the LEHLE PARAL-
LEL SW II.
7. Use the True-Bypass switch (12) to
switch between the original signal (LED
white) and the mix of the original and ef-
fect signals (the LED will then show blue).
8. Done!
LEHLE GmbH · Germany · www.lehle.com · support@lehle.com
Check the overall sound for any phase
cancellations and, if necessary, press the
phase reverse switch (4) on the LEHLE
PARALLEL SW II.
16