Lehle PARALLEL SW II Operating Instructions Manual page 11

According to the foot switch mode follow-
ing configurations are given:
- Latching Mode:
The LEHLE foot switch "latches" by a
press and release.
- Momentary Mode:
The LEHLE foot switch triggers a contact
and disconnects once released.
- Mixed Mode:
A mix between latching and momentary.
A short press lets the foot switch act as
latching, a longer press is momentary.
You will find out how to change the be-
haviour in chapter "Selecting the foot
switch mode" on page 12.
13. BASE AND FIXING
If required, mount the LEHLE PARALLEL
SW II to a pedalboard using the mount-
ing kit.
The LEHLE PARALLEL SW II can be mount-
ed to a plate such as a pedalboard using
the two holes in the bottom of the pedal.
You can find the optional LEHLE Mount-
ing Kit V3 (order number 100981) online
at www.lehle-components.com.
To mount, undo the four housing screws
by using a 2.5 mm Allen key and detach
the cover.
LEHLE GmbH · Germany · www.lehle.com · support@lehle.com
Then fix the device base to a base plate
using the two screws, the washers and the
spacers of the Mounting Kit.
Attach the cover and tighten the four
housing screws - done!
For flexible solutions we recommend us-
ing 3M Dual Lock™ instead of Velcro for
stability, which you can also find in handy
sizes at www.lehle-components.com
If you are using the Velcro / Dual Lock™
method, please make a note of the serial
number on the bottom of the pedal befo-
re you cover it, in case you have a sup-
port question for us later and don't fancy
dismantling your board!
11
!