Advertisement
Legend for the response indicators
out
Opening the detector
Damage to the connection cable
In order to prevent damage to the connection cable when positioning the housing cover,
make sure that the connection cable has been routed correctly.
The service area for the detector can be accessed in two ways.
●
Partial access:
–
–
●
Full access:
–
–
–
–
4
Building Technologies
Fire Safety
Operation
Blowing
Error
CAUTION
Remove the two screws on the top of the detector.
Slide the housing cover up until you hear it snap into place.
Remove the two screws on the top of the detector.
Slide the housing cover up until you hear it snap into place.
Pull the housing cover out slightly at the sides and lift it up.
Remove the housing cover.
1
Flow warnings
High flow
Normal flow
Low flow
2
Smoke alarm
Info alarm
Fire 2
No smoke
Fire 1
Fault/test
Pre-alarm
Dust
A6V10331032_j_en_--
2019-01-24
Advertisement
