aXbo Sleep.Phase.Alarm.Clock Instruction Manual page 8

4. Quick-set by one-click
Quick-set functions enable you to activate or deactivate a set alarm or set a new alarm
for a person.
Person 1 - Activate / Deactivate alarm
If the alarm is activated, it will be deactivated and vice versa.
>> Press [back] 10 button in standby mode for 2 seconds
Person 1 - Quick-set new alarm time
>> Press [back] 10 button once shortly in standby mode
>> [scroll] 11 hours > [click] 11 confirm
>> [scroll] 11 minutes > [click] 11 confirm
The alarm for person 1 is now set and activated. Alarm sound and volume remain unchanged.
aXbo will automatically return to standby mode.
Person 2 - Activate / Deactivate alarm
If the alarm is activated, it will be deactivated and vice versa.
>> Press [home] 12 button in standby mode for 2 seconds
Person 2 - Quick-set new alarm time
>> Press [home] 12 button once shortly in standby mode
>> [scroll] 11 hours > [click] 11 confirm
>> [scroll] 11 minutes > [click] 11 confirm
The alarm for person 2 is now set and activated. Alarm sound and volume remain unchanged.
aXbo will automatically return to standby mode.
16
5. Batteries & Mains Adapter
Battery operation
aXbo comes with three already installed AAA Ni-MH batteries. These can be recharged at any
time by using the adapter.
If batteries are fully charged, aXbo can run for up to 10 days without recharge. This makes
aXbo an ideal alarm clock to use also in households where power is cut-off from bedrooms
at night-time.
Note:
In order to save electricity, aXbo only receives signals up to 12 hours before the set alarm-time
when it is running on battery. In the remaining period it will not register any movements or show
them on the display.
If the display shows LOW.BAT and CHARGE, please plug in the adapter immediately to recharge
the batteries and ensure full function.
Caution:
As long as LOW.BAT and CHARGE are shown on the display,
are deactivated. You will then be woken at the last possible time in the same way as by a
conventional alarm clock.
Plug-in operation
aXbo uses an intelligent recharge system. Batteries will be only charged, once a certain low level
has been reached. Should you need the batteries fully charged (e.g. on travel), just pull out the
plug and plug it in again, this will start a complete charging cycle.
light and sleepphase alarm
17