aXbo Sleep.Phase.Alarm.Clock Instruction Manual page 12

6.6 Error correction
Error: Soft alarm sound doesn't sound (no ideal wake-up)
Did you wear the wristband? Is your sensor activated?
Solution: Press the [push] 14 button on your wristband shortly, the display light should come on;
if this is not the case, activate the sensor by pressing the [push]
wristband for 5 seconds, then release.
One of the rare days when your ideal wake-up point could not be established.
During battery operation:
If the display shows LOW.BAT / CHARGE optimum wake-up is not possible as the
battery level is too low.
Error: Unintelligible display message or no settings possible
Solution: Reset the alarm clock to get back to delivery status.
Caution: Your sleep data will be erased irrevocably!
During battery operation:
Batteries low: Display message LOW.BAT/ CHARGE
Solution: Plug in your adapter immediately!
Caution: Otherwise lights and sleep phase alarm are deactivated,
aXbo works like a conventional alarm clock.
Error: Sleep.Phase.Alarm.Clock cannot be switched on or does not react
Is the key lock activated? Does the display show HOLD BACK + HOME?
Solution: Unlock the keys by pressing [back]
[click] 11 confirm.
14 button on the
10 + [home] 12 together for 2 seconds >
24
Error: The display does not show any movements
Is your sensor activated?
Solution: Press [push] 14 shortly on your wristband, the display light should come on.
If not, activate your sensor by pressing [push]
During battery operation:
Check if your wake-up time is within the next 12 hours. Check if the display shows
LOW.BAT/CHARGE If yes, plug in the adapter. Is the key lock activated? Unlock the
keys by pressing [back] 1o +[home]
6.7 Data transfer
The Sleep.Phase.Alarm.Clock can store sleep data of 2 persons for a duration of 14 days.
You can transfer data from the alarm clock to the PC by using the USB cable.
Registered users can download a software to receive a graphic overview of their sleeping data
free of charge. Furthermore, the USB cable will enable you to download software updates.
For further information please refer to our website www.axbo.com
6.8 Producers' notes
Produced by: infactory innovations & trade gmbh, Mayergasse 5, A-1020 Vienna, Austria
Audio- & Sounddesign: Max Fürth @ noyz, www.noyz.biz
Grafics & artwork: Axel Ferro, www.f-ax.com
Industrial design: Rouven Haas, www.designment.cc
Photography: Christian Maricic, www.karafiat.at
14 continually for 5 seconds, then release.
12 together for 2 seconds > [click] 11 confirm.
25