Advertisement
INSTALLATION NOTES:
3. Product Installation (continued)
Concrete
Gravel
10. Fill hole with gravel ½" (13 mm) higher than the
lower drainage ledge.
11. Pour concrete up to grade.
12. Following sufficient concrete hardening (curing),
remove wood frame and installation cover.
13. Run incoming wiring from luminaire housing
through the wiring compartment cover. Connect
wiring using the wiring diagram and approved
wire connectors.
ARCHITECTURAL & LANDSCAPE LIGHTING
nBeckon-
26
12" (300 mm) +
Lead Exposed
14. Seal wiring compartment with cover by pressing
15. Place the housing inside the sleeve and rotate
16. Insert four screws (included) to secure in desired
|
holmlighting.com
in place completely.
according to the proposed directional of light.
position with an installation torque value of
50 in-lbs (5.6 Nm).
Customer Service 1-844-200-4656
4
Advertisement
