Advertisement
Available languages
Available languages
Install the U-Channel
5" (12.7 cm)
U-Channel
Hollow Seal
3. Install the "U" Channel
NOTE: Apply petroleum jelly to the hollow seal if needed to help it slide easier.
On the pivot side of the bottom track, pull the hollow seal 5" (12.7 cm) beyond the edge of the
bottom track.
Slide the hollow seal through the base of the U-Channel until it is 1" (2.5 cm) beyond the other end.
Slide the "U" channel onto the pivot end of the bottom track.
Adjust the "U" channel so the end is 1" (2.5 cm) from the pivot end of the bottom track.
Trim the excess hollow seal off each end of the bottom track.
4. Locate the Bottom Track
Locate the bottom track on the flattest section of the shower ledge.
Position the bottom track so the gaps between the track and the wall are identical at both ends.
Make sure the front edge of the bottom track is an equal distance from the front edge of the shower
ledge at all points.
Temporarily secure the bottom track to the ledge with masking tape, taking care to keep it in the
desired position.
Mark the location of the bottom track with a soft pencil.
Sterling
Bottom Track
Hollow Seal
1" (2.5 cm)
Locate the Bottom Track
Pivot Side
7
Front Side of
Bottom Track
Shower Floor
Ledge (Outside)
Strike Side
Masking Tape
1034026-2-D
Advertisement
