Perel EAC12S User Manual page 6

b. Auto, Refrigerating, Dehumidifying and Ventilation Mode
1. Insert the power plug into the mains. You will hear a double beep sound. Press the ON / OFF button to turn
on the unit. The LCD displays the environmental temperature and the operation mode (auto).
2. To select the operation mode, press MODE. The operation modes will change with each press in following
sequence: ...→ Auto → Cooling → Ventilation → Dehumidifying →...
3. The temperature is adjustable from 15°C to 31°C and can be read from the LCD. Press TEMP
increase the temperature by 1°C; press TEMP
4. Press SPEED to adjust the fan speed. The fan speed will change with each press in following sequence:
...→ Low Speed → Medium Speed → High Speed → ... The fan speed settings can be read from the
LCD.
5. Press the ON / OFF button to switch off the unit. You will hear a beep sound.
REMARKS
• When running the unit in dehumidifying mode, the fan will spin at low speed. The speed is not adjustable.
The temperature will also be constant and not be adjustable.
• The temperature is not adjustable when running the ventilation function.
• This unit has a memory function (except when in auto mode), i.e. all settings will be memorized at shutoff.
You will not need to reset the unit when switching it back on.
c. Auto ON / OFF Mode
Auto Switch Off
1. Press TIMER to set the automatic switch off time while the unit is working.
2. Each press on the TIMER button will modify the time setting from ½h to 12h.
Auto Switch On
1. Switch on the unit and press TIMER to set the automatic switch on time.
2. Each press on the TIMER button will modify the time setting from ½h to 12h.
REMARKS
• A displayed time on the LCD is automatically the switch off time if no switch on time has been set.
d. Adjusting the Wind Direction
• To modify the horizontal wind direction (left to right), press WIND.
• The vertical wind direction (up or down) can be modified manually.
e. Draining the Unit
Single Drainage
In cooling mode, the condensed water will automatically flow to the water tank. A full water tank will be
signaled by a buzzing sound and E4 will be displayed. The cooling function and the fan will automatically stop.
Before restarting the unit, empty the water tank.
• Gently slide out the water tank.
• Empty the tank and clean with water and some neutral cleanser if necessary. Dry off the tank.
• Replace the water tank back in the unit.
• Make sure to empty the tank when the unit is not in use.
EAC12S
to decrease the temperature with 1°C.
6
to
PEREL