Honda Click 125i 2017 Owner's Manual page 63

5. Remove the oil fill cap/dipstick, drain bolt
and sealing washer to drain the oil.
6. Remove the oil plug, O-ring, spring and
oil strainer screen and let the remaining
oil drain out.
Discard the oil at an approved
u
recycling centre.
7. Clean the oil strainer screen.
8. Check that the oil strainer screen and
sealing rubber are in good condition.
9. Replace the O-ring and apply a thin coat
of engine oil to the new O-ring before
installing it.
10. Install the oil strainer screen, spring and oil
plug and tighten.
Torque: 20 N·m (2.0 kgf·m, 15 lbf·ft)
11. Install a new sealing washer onto the drain
bolt. Tighten the drain bolt.
Torque: 24 N·m (2.4 kgf·m, 18 lbf·ft)
Engine Oil Changing Engine Oil, Cleaning Strainer Screen
u
Sealing washer
Drain bolt
Spring
Oil plug
Oil strainer screen O-ring
continued 59