Table of Contents
Advertisement
IPLink
4.3.2. Merging the Ethernet
Signals with a Switch
If two IPLink Cards are connected to an
IPLink module, use a switch to merge the
signal going to the antenna. To prevent IP
conflicts, do not use a router for this purpose
unless the direct internet connection is made
in this building.
1. Connect the IPLink Card for controller
networks in the 1
st
2. Connect the IPLink Card for Feedlink net-
works to the 2
port of the switch.
nd
3. Connect the "LAN" connector of the PoE
device to the 3
port of the switch.
rd
4. Connect the power cord of the switch to
any power outlet located on the BATTERY
SIDE of the UPS.
The switch is not dust and moisture
proof. It should either be located in
a clean environment or placed in a
dust & watertight enclosure such as
the optional Medium White ABS Box.
Before plugging the switch into the
UPS, make sure the battery of the
UPS device is properly connected.
Refer to the user's manual of the UPS.
Only use the UPS included with your
A-BOX system.
port of the switch.
4.3.3. Connecting the PoE device
1. Connect the "LAN" connector of the PoE
device to Ethernet connector on the IPLink
Card (or in the switch if two IPLink Cards
are used).
2. Connect the "POE" connector of the PoE
device to the antenna.
T
he Ethernet cable coming from the
antenna must be curved downwards
right before it is connected to the PoE
device to avoid dripping condensa-
tion and water into the PoE device.
3. Connect the power cord of the PoE device
to any power outlet located on the BATTERY
SIDE of the UPS.
The PoE device is not dust and mois-
ture proof. It should either be located
in a clean environment or placed in a
dust & watertight enclosure such as
the optional Medium White ABS Box.
Before plugging the PoE device into
the UPS, make sure the battery of
the UPS device is properly connected.
Refer to the user's manual of the UPS.
Only use the UPS included with your
A-BOX system.
15
IPLink, rev.01
Advertisement
Table of Contents
