Table of Contents
Advertisement
IPLink
• IPLink Card for Feedlinks
Description
If the A-BOX uses a Feedlink network, an
IPLink Card for Feedlinks must be connected
to each IPLink module on site.
End of line selector
END OF LINE
J3
YES
NO
Figure 5. IPLink Card for Feedlink Networks
14
IPLink, rev.01
Ethernet
connector
ON
OFF
1 2 3 4 5 6 7 8
Dipswitches
D9
D8
Installation
1. Setting the End of Line (EOL) — If the
IPLink module is in the middle of a com-
munication network, set the end of line
(EOL) jumper to "No"; if it is located at the
beginning or end of the network, set the EOL
jumper to "Yes".
Jumper at
"No" position
If the IPLink module is located at
the beginning of the communication
line, set the EOL jumper to "Yes" on
the IPLink Card.
2. Connecting the Ethernet Cable — Connect
an Ethernet cable to the IPLink Card and to
the LAN connector of the antenna's PoE
device. If two IPLink Cards are connected to
the IPLink, use a switch to share the signal
going to the PoE device.
3. Connecting the Card
Before plugging the card, make sure
dipswitch #1 is at the "ON" position
(all other switches must be OFF).
ON
OFF
D7
D6
1 2 3 4 5 6 7 8
Plug the IPLink Card to the CARD2 connec-
tor in the IPLink module. Be sure to line up
the ground connector with the metallic pin
located on the main board while inserting
the card.
Jumper at
"Yes" position
Figure 6. EOL positions
END OF LINE
J3
NO
YES
Advertisement
Table of Contents
