Table of Contents
Advertisement
IPLink
4.3.1. IPLink Cards
IPLink Cards allows the IPLink module to
convert different kind of controller signals
into Ethernet signals. At least one IPLink Card
must be connected to each IPLink module.
Two models of IPLink Cards are currently
available: one is for the standard TC5/TC6/
Expert/Provision network and the other for
Feedlink network.
IMPORTANT:
A serial number is located at the
back of each IPLink Card. Write
down the serial number and location
of each IPLink card in use in
ANNEX1 of the A-BOX Installation
Guide. During the Commissioning
process, the A-BOX will refer to this
serial number to locate the wire-
less antenna(s) on site. Without this
number in hand, you will not be able
to associate the controllers with
their building.
Reset Procedure
To reset an IPLink Card:
1. Gently pull out the card from its connector.
2. Wait 10 seconds.
3. Plug the card back into the connector.
• IPLink Card for Controllers
Description
If the A-BOX uses a standard TC5/TC6/Ex-
pert/Provision network, an IPLink Card must
be connected to each IPLink module on site.
Installation
1. Connecting the Ethernet Cable — Connect
an Ethernet cable to the IPLink Card and to
the LAN connector of the antenna's PoE
device. If two IPLink Cards are connected to
the IPLink, use a switch to merge the signal
that goes to the PoE device.
2. Connecting the Card — Plug the IPLink
Card into the CARD1 connector in the IPLink
module. Be sure to line up the ground con-
nector with the metallic pin located on the
main board while inserting the card.
Ethernet
connector
Figure 2. IPLink Card
11
IPLink, rev.01
Advertisement
Table of Contents
