Sata Mode Selection [Ahci]; Aggressive Lpm Support [Disabled]; Smart Self Test [On]; Pch-Fw Configuration - Asus PRIME Z390-P Manual

SATA Mode Selection [AHCI]

Allows you to set the SATA configuration.
[AHCI]
[Intel RST Premium With
®
Intel Optane System
®
Acceleration (RAID)]*

Aggressive LPM Support [Disabled]

This item is designed for LPM (link power management) support with a better energy saving
conditions. When disabled, the hot plug function of SATA ports are disabled. Configuration
options: [Disabled] [Enabled]

SMART Self Test [On]

SMART (Self--Monitoring, Analysis and Reporting Technology) is a monitoring system that
shows a warning message during POST (Power--on Self Test) when an error occurs in the
hard disks. Configuration options: [On] [Off]
SATA6G_1~4(Gray)
SATA6G_1~4(Gray) [Enabled]
Allow you to enable/disable the SATA6G_1~4 port. Configuration options: [Disabled]
[Enabled]
SATA6G_1~4 Hot Plug [Disabled]
These items allow you to enable/disable SATA Hot Plug Support. Configuration
options: [Disabled] [Enabled]
2.6.6

PCH-FW Configuration

ME State [Auto]
This item allows you to enable or disable the ME State. Configuration options: [Enabled]
[Disabled] [Auto]
Intel Platform Trust Technology [Disabled]
This item allows you to enable or disable the Intel Platform Trust Technology (PTT).
Configuration options: [Enabled] [Disabled]
2.6.7 Onboard Devices Configuration
Hyper M.2X16 [Enabled][Disabled]
[Disabled] Only one SSD installed onto the Hyper M.2 X16 card can be detected.
[Enabled] Two or three SSDs installed onto the Hyper M.2 X16 card can be detected.
ASUS PRIME Z390-P
Set to [AHCI] when you want the SATA hard disk drives to
use the AHCI (Advanced Host Controller Interface). The AHCI
allows the onboard storage driver to enable advanced SATA
features that increases storage performance on random
workloads by allowing the drive to internally optimize the order
of commands.
Set to [Intel RST Premium With Intel
®
Acceleration (RAID)] when you want the SATA hard disk
drives to use Intel RST Premium interface or you want to
®
create a RAID configuration from the SATA hard disk device.
Optane System
®
2-33