Table of Contents
Advertisement
INTRODUCTION
Device Description
petMAP+II is a small, lightweight and portable battery operated
monitoring device designed for veterinary use. In its various base unit
configurations, it is capable of measuring blood pressure (systolic, diastolic
and mean arterial pressures), heart rate, temperature and oxygen
saturation (SpO2). The measured values are displayed and trended on the
device continuously. Data trended on the petMAP+II can optionally be
saved on a SD memory card via the petMAP+II's integrated SD memory
card slot.
Modules for ECG and CO2 can also be purchased and added to the base
unit.
The CO2 Module incorporates a mainstream type of CO2 sensor for use on
intubated patients and allows the petMAP+II to display the capnograph as
well as the CO2 values: ETCO2 (End Tidal CO2), InspCO2 (Inspired CO2),
RtCO2 (Realtime CO2) and RRCO2 (Respiration Rate from the CO2
waveform). The CO2 sensor resides on the airway and has a nine‐foot
cable that plugs into the connector labeled "CO2" on the side of the
petMAP+II. The Module includes two airway adapters, one for larger
endotracheal (ET) tubes and one for smaller ET tubes.
Intended Uses
petMAP+II is intended for use on veterinary patients when measuring or
monitoring of blood pressure, heart rate, temperature and/or SpO2 is
desired. When configured with a mainstream CO2 Module, the petMAP+II
will also display the CO2 waveform, CO2 values and RRCO2. It can be used
on a wide variety of veterinary patients, but is primarily designed for
companion animals. When equipped with the CO2 module, petMAP+II can
be used on anesthetized patients with ET tubes. Applications include use
for surgical, ICU and trauma monitoring as well as use during procedures
(imaging, dentals, etc.) in which an ET tube is used.
5
Advertisement
Table of Contents
