Maintenance Schedule; Troubleshooting; Technical Data - Makita EE400MP Instruction Manual

Maintenance schedule

Operating hour
Whole unit
All fixing screws and nuts
Gear case
Drive axle
Cutter blade
Power unit

Troubleshooting

Problem
The engine does not start.
The engine stops soon after its start.
The maximum speed is limited.
The cutting tool does not rotate.
Stop the motor immediately!
The unit vibrates abnormally.
Stop the motor immediately!
The cutting tool does not stop.
Stop the motor immediately!

Technical Data

Model
Dimensions (L x W x H)
Net weight (Not including protector and blade)
Cutting blade diameter
Gear ratio
Visually inspect for damaged
parts
Tighten
Supply grease
Supply grease
Visually inspect for damage
Refer to the instruction manual of the power unit
Probable cause
Refer to the instruction manual of the power unit.
The cutting blade is not tightened securely.
A twig is caught between the cutting blade
and the protector.
The drive system does not work properly.
The cutting blade is bent, worn or broken.
The cutting blade is not tightened securely.
The cutting blade is not fitted on the receive
washer.
The drive system does not work properly.
The power unit does not work properly.
mm (inch)
kg (lbs)
mm (inch)
Before
Daily (10h)
Operation
Tighten the cutting blade securely.
Remove the foreign matter.
Ask Makita authorized service center to
inspect and repair it.
Replace the cutting blade with new one.
Tighten the cutting blade securely.
Install the cutting blade properly.
Ask Makita authorized service center to
inspect and repair it.
Refer to the instruction manual of the power
unit.
878 x 131 x 291 (34-1/2" x 5-1/8" x 11-1/2")
8
Corresponding
30h If required
Solution
EE400MP
2.4 (5.4)
203 (8")
14/29
page
7
7
6
7
6