Mitsubishi Electric PZ-61DR-E Instruction Book page 32

Controller operation-Function settings
Function setting
3
M-NET address
Function No.
Data
Function
Select:
Cursor
F1
M-NET address
Function No.
Data
4
M-NET address
Function No.
Data
Setting completed
Return:
F1
32
Function setting
3
32
2
Set / Conf
Address
F2 F3 F4
Function setting
3
32
2
Sending data
Function setting
3
32
2
F2 F3 F4
The Function Setting screen will appear.
Press the F1 or F2 button to move the cursor
to one of the following: M-NET address, function
setting number, or setting value. Then, press the
F3 or F4 button to change the settings to the
desired settings.
Once the settings have been completed, press
the SELECT button.
A screen will appear that indicates that the
settings information is being sent.
To check the current settings of a given unit, enter
the setting for its M-NET address and function setting
number, select Conf for the Function, and press the
SELECT button.
A screen will appear that indicates that the settings
are being searched for. When the search is done, the
current settings will appear.
When the settings information has been sent, a
screen will appear that indicates its completion.
To make additional settings, press the RETURN
button to return to the screen shown in Step
3 above. Set the function numbers for other
Lossnay units by following the same steps.
Navigating through the screens
To return to the Service Menu screen ...... MENU button
To return to the previous screen ...... RETURN button
OFF
P