TMC Aquarium REEF EASI-Dose Plus Series Instructions For Installation And Use Manual page 3

INSTRUCTIONS FOR INSTALLATION AND USE
Important Safety Information - Please Read Carefully
- Always isolate from the mains electricity before installing or carrying out any
maintenance to the EASI-Dose Plus dosing system.
- Power to the EASI-Dose Plus dosing system must be supplied through a Residual Current
Device (RCD) with a rated residual operating current not exceeding 30mA.
- Pump rating: 220-240V, 50Hz unless marked otherwise.
- Do not operate any appliance if it has a damaged cord or plug, if it is malfunctioning, or if it
has been dropped or damaged in any way.
- This unit is designed to be used indoors and is not suitable for any outdoor applications.
- Ensure the EASI-Dose Plus dosing system is safely positioned before operating.
Caution: The EASI-Dose plus Dosing system is not waterproof and therefore must not be
mounted above the aquarium or sump, or in any position where it may accidentally fall into
water or be splashed by water, or in a humid environment.
- Always leave a drip-loop in the cables to prevent water running down the cable and
reaching the power source (see below).
- Dispose of this unit responsibly. Check with your local authority for disposal
information.
Drip Loop
1