Advertisement
3.
Attach each of the mounting plates with four screws unto the ceiling. Here pay attention to the position of the electrical
connection.
4.
- Lift up the packaging including the hood with at least 2 persons. Make sure that the connecting cable is on the right-
hand side.
- Position the packaging/hood at a certain height, making sure that the mounting cables can easily be placed into the
mounting plates.
- Take the ends of the four mounting cables and insert them into the holes of the mounting plates and pull them through
the slot downwards, as shown in the figure.
The height adjustment will be dealt with later (illustration 6)
5. Electrical connection:
Slide the closing plate over the mounting cables until it almost touches the mounting plate. Connect the power supply
cable to the connector. Replacement of the connection cable is to be done by a qualified installer. The amperage and the
energy consumption have been indicated on the specification label attached to the inside of the hood.
The hood does not have an on/off switch. For this reason the fixed wiring is to be provided with a circuit breaker
(double pole switch or safety switch with a minimum contact distance of 3 mm).
6.
Slide both closing plates over the cables until they touch the mounting plates. Attach each closing plate with two
screws into the mounting plate.
7. Adjust the height:
The height of the hood with respect to the ceiling can be between 250 and 1500 mm. The recommended mounting height
for an electrical or ceramic cooking plate is min. 600 mm and max. 850 mm. The mounting height for a gas or induction
cooking plate is min. 650 mm and max. 850 mm.
The cable clamps are found at the place where the cable enters the hood. The cable can be extended by pressing this
cable clamp. The cable will be locked as soon as the cable clamp is no longer pressed. The cable can still be slid in at this
moment. The visible length of the power supply cable can be adjusted by sliding it into the hood.
ATTENTION:
• While adjusting the cables, support the hood in order to prevent it from falling.
• Do not exceed the maximum height to the ceiling (1500 mm).
Carefully remove the hood from the packaging.
Optionally, an accessory with four longer cables of 3,5 metres can be ordered (item number 7550100).
EN 15
Advertisement
