Bissell POWERFORCE TURBO REWIND 1797 Series User Manual page 9

Cleaning the Separator
1
Press the tank
release button
and pull handle
to lift dirt tank
away from
vacuum.
Replace the Brush & Belt
1 2
Unplug vacuum, turn
Lift roller straight out.
over and unscrew 6
Inspect belt, replace if
Philips head screws to
it appears damaged.
remove bottom cover.
4
Belt
Replace the brush roll and belt
by looping the belt over the
motor shaft and the brush roll.
Line up the end caps and pull
the brush forward into place.
This will stretch the belt.
End Cap
2
Remove the separator
by twisting to the left
(counterclockwise), then
pull it out through the
bottom of the tank. Rinse
and dry all sections of dirt
tank with paper towel.
3
If the belt is not broken, remove
roller from inside of looped
belt. Inspect brush roll by
placing it on its end and spin.
The brush roll should spin freely,
multiple times by one flick. If it
doesn't, replace brush roll.
5
Once the brush roll is installed,
place the bottom cover back on
and replace the screws.
www.BISSELL.ca
9