Safety Instructions - Victron energy Lynx Ion Manual

1

SAFETY INSTRUCTIONS

1.1 In general
Please read the documentation supplied with this product first, so that you are familiar with
the safety signs en directions before using the product.
This product is designed and tested in accordance with international standards. The
equipment should be used for the designated application only.
WARNING: DANGER OF ELECTRICAL SHOCK
The product is used in combination with a permanent energy source (battery).
Even if the equipment is switched off.
The product contains no internal user-serviceable parts. Do not remove the front panel and
do not put the product into operation unless all panels are fitted. All maintenance should be
performed by qualified personnel.
Never use the product at sites where gas or dust explosions could occur. Refer to the
specifications provided by the manufacturer of the battery to ensure that the battery is
suitable for use with this product. The battery manufacturer's safety instructions should
always be observed.
WARNING: do not lift heavy objects unassisted.
1.2 Installation
Read the installation instructions before commencing installation activities.
Ensure that the connection cables are provided with fuses and circuit breakers. Never
replace a protective device by a component of a different type. Refer to the manual for the
correct part.
Check before switching the device on whether the available voltage source conforms to the
configuration settings of the product as described in the manual.
Ensure that the equipment is used under the correct operating conditions. Never operate it
in a wet or dusty environment.
Ensure that there is always sufficient free space around the product for ventilation, and that
ventilation openings are not blocked.
Install the product in a heatproof environment. Ensure therefore that there are no chemicals,
plastic parts, curtains or other textiles, etc.in the immediate vicinity of the equipment.
2