Slidewriter Error Codes - AGFA SLIDEWRITER Owner's Manual

SlideWriter Error Codes

34
Error codes are intended as a guide to the operator or programmer.
Even though the SlideWriter has an extensive set of error codes, do
not attempt a form of automatic error recovery. In most instances,
and error code means that the SlideWriter has exposed incorrect
information on film.
When the SlideWriter detects an error, it reports the error by
illuminating the ERROR or FAULT lights and displays an error code
in hexadecimal on the current Exposure Display referred to as a
"primary error code". The following table explains the primary error
codes:
Primary Code
83
84
86
91
92
93
A2
Table 5-3. Primary Error and Fault Code Interpretations
When an error or fault occurs, the SlideWriter emits a warbled beep
every 15 seconds. During the 15 second interval between warbled
beeps, and before the host processor sends a REQUEST SENSE
command, press the FUNCTION Switch to display a secondary error
code on the Current Exposure Display.
After having displayed the secondary error code, display the
contents of the SlideWriter's internal registers to obtain even more
information This is accomplished by pressing the SELECT Switch.
The SlideWriter displays the registers in the following order: H, L, D,
E, B, C. After the SlideWriter displays register C, press the
FUNCTION Switch to return the SlideWriter to the primary error
display.
Problem
Illegal Command
Illegal Data Byte
Illegal SCSI Address
Memory Fault
SCSI Interface Fault
CRT Beam Calibration Fault
Filter Wheel Fault