Eplacement; Electronic Configuration - Econex AB1 SE Series Installation And Operating Instructions Manual

12 REPLACEMENT
In case replacement of the AB1...SE gear motor is necessary, proceed as follows:
- disconnect power supply from the gear motor
- remove the gear motor's cover
- disconnect electronic wiring taking note of the cables' numeration
- remove all levers between the AB1...SE gear motor and the controlled device
- install the new AB1...SE gear motor proceeding as per the instructions given in the
foregoing chapters
13

ELECTRONIC CONFIGURATION

The digital electronic board mounted on AR2 gear actuator enables to set various features
/ options, like rotation direction, resolution, type of input control signal and impedance.
W
ARNING
For each model there is a specific electronic board, with its own specification in hardware
and software.
The desired configuration can be obtained by setting dip-switch of the electronic board on
the right or left hand side, according to the below indicated schemes.
Dip-switches are located under the paperboard panel over the horizontal board. Lift the
rectangular paperboard to access the dip-switches
AB1...SE instructions
Form 140516
9 of 12