Table of Contents
Advertisement
5
CABLE CONNECTIONS
5.1
T
ERMINAL BOARD
Terminal
Terminal 1
Terminal 2
Terminal 3
Terminal 16
Terminal 17
5.2
A
UXILIARY MICROSWITCHES
Terminal 20
Terminal 21
Terminal 22
Terminal 23
Terminal 24
Terminal 25
5.3
O
P
PTIONAL
OTENTIOMETER FOR ANSWER SIGNAL OF
Terminal 33
Terminal 34
Terminal 35
6
AUXILIARY MICROSWITCHES
On request, AB1...SE gear motor is supplied with 2 auxiliary microswitches, which can be
adjusted in any position.
Microswitches are voltage-free.
Contact rating is about 0,5 A/ 48 Vdc and Vac with Ohm load and about 1 A/250 with
inductive load.
For adjusting the cams of auxiliary microswitches, proceed as for cams of endswitches as
indicated in paragraph 9.1 of § 9 ADJUSTMENTS.
AB1...SE instructions
Form 140516
earthing
24 Vac / 50 – 60 Hz
no tension
by increasing input signal the gear motor shaft rotates counter
clockwise
[opens]
answer signal when the gear motor reaches the position "open"
answer signal when the gear motor reaches the position "closed"
common contact of the auxiliary microswitch S3
normally open contact of the auxiliary microswitch S3
normally closed contact of the auxiliary microswitch S3
common contact of the auxiliary microswitch S4
normally open contact of the auxiliary microswitch S4
normally closed contact of the auxiliary microswitch S4
max. value
slider
min. value
P
. B
OT
POSITION
5 of 12
Hide quick links:
Advertisement
Table of Contents
