Operation & Adjustment Procedures; Machine Set - Up Adjustments; Case Width - Pro Mach Wexxar BEL Series Operation & Service Manual

B E L 5 0 5 / 5 0 5 S S
O & A
PERATION
Switch off or disconnect the air supply to the machine before making any changes or
M S -
ACHINE ET UP
Setting up the BEL 505 & 505 'S' to fold a particular box size is accomplished with two main
adjustments for case width and length. There is a third adjustment to reposition the major flap folder
plates that, after initial setup, will need to be changed only where there is a large difference between cases
widths.
C W
ASE IDTH
1. Loosen the hand
knobs at the end
of the BEL 505
or 505 'S'.
2. Attach the hand
crank supplied
with the machine
on the square
shaft that extends
from either side
of the frame.
Adjust the frame
to be wider than
the case.
3. Open a case from the flat blank and insert it into the m
4. Crank in the width adjustment until the red case
hold-down rollers are lightly gripping the sides
of the case. It should be easy to insert and
remove the case without forcing but it must
maintain contact on the white "body " switch
roller until the case leaves the machine.
5. Re-tighten the hand knobs.
65-11-7 2/5/2007
- A
E M I U T O M A T I C
DJUSTMENT
S A F E T
S A F E T
adjustments.
A
DJUSTMENTS
C F
A S E O R M E R
P
ROCEDURES
Y C A U T I O
Y C A U T I O
achine.
Case hold-
down roller
& P S
A C K T A T I O N
N
N
"Body"
switch roller
8