Specifications; Déclaration De Conformité Ce - Binks HGB-509 Series Operator's Manual

  DESCRIPTION
Manually adjusted or remote air pressure controlled, these fluid regulators can provide material at
constant pressure for one or two spray guns, using stainless steel ball valve and spring, " Perlast"
valve seat. Especially design for application with low paint viscosity and needing accurate fluid
flow regulation (Low hysteresis level).
  SPECIFICATIONS
Type
Order number
Reg
HGB-509-5-R38
HGB-609-1.2-R38
HGB-609-5-R38
HGB-609-9-R38
HGB-510-R1
HGB-510-R2
HGB-510-R4
HGB-510-R1-CO
HGB-510-R2-CO
HGB-510-R4-CO
All the fluid passages are in stainless steel (303), membrane in Teflon, cover in aluminum nickel
treatment for manual model or anodized for remote air control.
The regulators HGB-609 are equipped with stainless steel tee and riser tube and a manometer. The
tightness of these connections ought to be perfect so to protect the manometer.
See drawings on « Accessories ».
IMPORTANT : These regulators may be used with most common coating and finishing materials.
However, there are not designed for use with highly corrosive materials which have such
characteristics, it must be expected that frequent and thorough cleaning will be required and/or the
necessity for replacement of parts will be increased.
  DÉCLARATION DE CONFORMITÉ CE
We, ITW Surfaces et Finitions, 163,171 avenue des Auréats BP 1453,
20014 Valence Cedex France, as the manufacturer of Fluid regulator
model HGB-510/509/609, declare under our sole responsibility, that the
equipment to which this document relates is in conformity with the
following standards or other normative documents :
EN 292-1 PARTS 1 & 2: 1991, EN 1953: 1999; and thereby conform
to the requirements of; Council Directive 98/37/EC relating to
Machinery Safety Directive.
These regulators are classed as components, by the ATEX directive
94/9/EC " Equipment and Protective Systems intended for use in
Potentially Explosive Atmospheres" and are in conformity with the
provisions of the directive, protection level II 2 G
ITW Surfaces & Finition reserve the right to modify
equipment specification without prior notice.
SB-6-HGB-H
Thread
Inlet Outlet
Male
Female
3/8 NPS
3/8 BSP
/ BSP
Female Female
1/4 BSP 1/4 BSP
Male
Female
3/8NPS/
3/8 NPS
BSP
Director : Claude FERRET
11/40
Inlet Outlet
pressure pressure
min-max.bar max.bar
2 - 12,5 5
1 - 8 1.2
2 - 12,5 5
3 - 15 9
2 - 15 15
1 - 15 7
1 - 15 4
2 - 15 15
1 - 15 7
1 - 15 4
Fluid flow Mano-
maximum meter
L/min bar
13 No
8,3 0 - 2,5
13 0 - 6
13 0 - 10
1,6 No
(Tip 1.1mm)
1,3 No
(Tip 1.1mm)
0,8 No
(Tip 1.1mm)
1,6 No
(Tip 1.1mm)
1,3 No
(Tip 1.1mm)
0,8 No
(Tip 1.1mm)