Adjustment Mode - Star Micronics SP500 Series User Manual

6-4. Adjustment Mode

There are the following four adjustment modes.
The device will enter the adjustment mode if your turn it on while pressing the
FEED switch.
The Self Printing Mode is entered by releasing the FEED switch after the buzzer
sounds once.
Adjusting the Dot Alignment Mode is entered by releasing the FEED switch after
the buzzer sounds twice.
(Refer to Appendix G.)
The Hexadecimal Dump Mode is entered by releasing the FEED switch after the
buzzer sounds three times.
The Black Mark Sensor Alignment Mode is entered by releasing the FEED switch
after the buzzer sounds four times.
(Refer to Appendix H.)
If the buzzer sounds five times or more, immediately turn the power off as the
adjustment mode is cancelled.
(Holding down for 2 more seconds)
M
(Holding down for 2 more seconds)
M
(Holding down for 2 more seconds)
M
M
– 22 –