Watts AERCO INN 600N Design Manual
Innovation water heaters with edge [i] controller
Hide thumbs
Also See for AERCO INN 600N:
- Installation, operation and maintenance manual (170 pages) ,
- Manual (39 pages)
Advertisement
Quick Links
Electrical Power Design Guide
Innovation Water Heaters
With Edge [i] Controller
Applies to models:
•
INN 600N
•
INN 800N
•
INN 1060N
•
INN 1350N
Disclaimer
The information contained in this manual is subject to change without notice
from AERCO International, Inc. AERCO makes no warranty of any kind with
respect to this material, including, but not limited to, implied warranties of
merchantability and fitness for a particular application. AERCO International is
not liable for errors appearing in this manual, not for incidental or
consequential damages occurring in connection with the furnishing,
performance, or use of these materials.
TAG-0092 • GF-5066 • 9/6/2019
AERCO International, Inc. • 100 Oritani Drive • Blauvelt, NY 10913
USA: T: (845) 580-8000 • Toll Free: (800) 526-0288 • AERCO.com
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Heating and Hot Water Solutions
© 2019 AERCO
Advertisement
Related Manuals for Watts AERCO INN 600N
Summary of Contents for Watts AERCO INN 600N
- Page 1 Electrical Power Design Guide Innovation Water Heaters With Edge [i] Controller Applies to models: • INN 600N • INN 800N • INN 1060N • INN 1350N Disclaimer The information contained in this manual is subject to change without notice from AERCO International, Inc. AERCO makes no warranty of any kind with respect to this material, including, but not limited to, implied warranties of merchantability and fitness for a particular application.
-
Page 2: General Information
Innovation Water Heaters – Edge [i] Controller Electrical Power Design Guide 1 General Information Innovation-Edge (INN) Water Heaters are fully factory wired and packaged units which require simple power wiring as part of the installation. This technical guide is intended to help designers provide electrical power wiring (line voltage) to Innovation-Edge units. -
Page 3: Power Box
Innovation Water Heaters – Edge [i] Controller Electrical Power Design Guide TERMINAL BLOCK FOR 110 VAC UNITS NOTE Terminal block will specify 220 POWER BOX VAC for international units Power Box Shown With Cover Removed Figure 2. Terminal Block Location 2.1 220V Input Power Innovation-Edge units operate internally on 120 VAC power. -
Page 4: Unit Wiring
Innovation Water Heaters – Edge [i] Controller Electrical Power Design Guide panels for maintenance. The disconnect switch should be mounted near the unit as illustrated in Figure 1. Wiring conduit, EMT, or other wiring paths should not be secured to the unit, but supported externally. - Page 5 Innovation Water Heaters – Edge [i] Controller Electrical Power Design Guide TERMINAL BLOCK IN 220 VAC 1 PHASE L2/N POWER BOX DISCONNECT SWITCH SINGLE-POLE, 10 AMP 1 POLE 10 AMP CIRCUIT BREAKER GND L2/N L1 Figure 5. 220, Single Phase Wiring Schematic 5 Multiple Unit Wiring Whenever multiple units are installed within the same mechanical spaces, electrical code requirements call for a single electrical shutoff for emergency use.
-
Page 6: Change Log
Innovation Water Heaters – Edge [i] Controller Electrical Power Design Guide Change Log: Date Description Changed by 9/6/2019 Rev A: Initial release © AERCO International, Inc., 2019 TAG-0092 • GF-5066 • Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST 9/6/2019 Page 6 of...