Advertisement
Mounting:
Front Mount 13x 3/8" hole, 2x 3/8" long hole, 4x M8 long hole. (drawing 2)
Turning the Front Mount under or over slung. Release 5 x M8 screws, turn around, and fix it
again.
drawing 2
Back Mount 49 threads (3/8")(Drawing 4) for clamps and connectors available.
Mount the Hybris Shock Absorber to the 50 mm speed rails with 2-4 clamps. (Drawing 3)
Make a quick estimation of the mounting height, so that the set up isn't mounted too low on
the tube/s. This could result that the camera is hitting the ground at the bottom of the shock
absorber boom range.
At this point, a quick estimation is all that is needed. You can fine tune this later, when you
have the gimbal and camera rigged.
Mount your gimbal and camera with all the accessories needed for your shoot, batteries
lenses cables etc., and let it float freely on the Hybris Shock Absorber.
drawing 3
Advertisement
