Federal Communications Commission; Radio Frequency Interference; Trademark Acknowledgement - Star Micronics NL-10 User Manual

Star micronics dot-matrix printer users manual

Hide thumbs

Table Of Contents

Table of Contents

This equipment generates and uses radio frequency energy and if not installed and used

properly, that is, in strict accordance with the manufacturer's instructions, may cause

interference to radio and television reception. It has been type tested and found to com-

ply with the limits for a Class B computing device in accordance with the specifications

in Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protec-

tion against such interfernce in a residential installation. However, ther is no guarantee

that interfernce will not occur in a particular installation. If this equipment does cause

interference to radeo or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient the receiving antenna

• Relocate the conputer with rewpect to the receiver

• Move the computer away from the receiver

• Plug the computer into a different outlet so that computer and receiver are on

different branch circuits.

If necessary, the user should consult the dealer or an experienced radio/television tech-

nician for additional suggestions. The user may find the following booklet, prepared by

the Federal Communications Commission helpful: "How to Identify and Resolve Ra-

dio-TV Interference Problems." This booklet is available from the U.S. Govertnment

Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.

For compliance with Federal Noise Interference Standard, this equipment requires a

shielded cable.

This statement will be applied only for the printers marketed in U.S.A.

Radio interferences regarding this equipment has been eliminated according to Vfg

1046/1984 announced by the DBP.

DBP has been informed about the introduction of this special equipment and has been

conceded the right to examine the whole series.

It is upon the responsibility of the user to assume that his own assembled system is in

accordance with the technical regulations under Vfg 1046/1984.

To observe FTZ-regulations it is necessary, to establish all connections to the printer

with shielded cable.

The equipment may only be opened by qualified service representatives.

This statement will be applied only for the printers marketed in West Germany.

NL-10: Star Micronics Co., Ltd.

NOTICE

ever, without STAR'S express permission is forbidden.

• The contents of this manual are subject to change without notice.

• All efforts have been made to ensure the accuracy of the contents of this manual at

the time of going to press. However, should any errors be detected, STAR would be

greatly appreciate being informed of them.

• The above notwithstanding, STAR can assume no responsibility for errors in this

manual.