Using The Paper Window - Star Micronics LC-90 NX-1010 User Manual

24 User Setup Utility

Using the Paper window

While in the User Setup Utility, select Paper from the menu bar.
The following describes the various settings that are available for each
parameter on this screen.
Page Length
Specify the length of the paper you are using.
Line Spacing
Select the line spacing you want to use.
Auto LF with CR
Switch auto LF with CR on (Enabled) or off (Disabled).
When auto LF (line feed) with CR (carriage return) is disabled, the computer
must send both a line feed code and a carriage return code at the end of each line.
Most applications do this automatically. When auto LF with CR is enabled, the
printer automatically performs a line feed whenever it receives a carriage return
from the computer.
Note the following check points when trying to figure out which setting to use
here:
If you find that your output is double-spaced when it should not be, change
this setting to Disabled.
If you find that lines are printing over each other, change this setting to
Enabled.
Exit Load Save General
Page- (•) 11 inch
Length ( ) 8 inch
Line- (•) 1/6 Inch
Spacing ( ) 1/8 Inch
Auto LF (•) Disabled
with CR ( ) Enabled
Top- (•) 1/6"
Margin
Current Data: Current Paper Setting
TAB = Next Box = Scroll up
= Scroll down
SPACE = Set Function
Font Paper Adjust.
Paper- (•) Enabled
*
Out ( ) Disabled
Tear- ( ) Enabled
*
Off (•) Disabled
Timeout (•) Enabled
*
Printing ( ) Disabled
*
Port Help
*
*
*
= Menu Select