Star Micronics LC-90 NX-1010 User Manual page 22

16 User Setup Utility
Execute the command that installs the User Setup Utility:
A:\>SETUP
Select the language you want to use. and then press Enter.
The above screen appears in the language that you selected in the previous
step.
Input the drive and directory names where you want the User Setup Utility
stored. The following is the default directory name that creates a directory
named "star" on your hard disk (drive C:) to store the User Setup Utility.
C:\star
You can use the left and right arrows, Delete and Back space when
making changes in the box that contains the drive and directory names. If
you require assistance while this screen is shown, press F1 for help.
After you specify drive and directory names, press Enter.
The User Setup Utility program is started up as soon as you press Enter, so
you can use the pull-down menus to make the setup changes you want.
Star LC-90 / NX-1010 Installation of User Setup Utility Version 1.0
Please select Language
English
Deutsch
Français
Italiano
= Enter = Scroll up
Star LC-90 / NX-1010 Installation of User Setup Utility Version 1.0
Please Select Drive and Directory for Installation
Directory: C:\star_
The HDD installation uses xxxKB of hard disk.
You may install this Printer Setup Utility onto a floppy disk if required,
please see the users manual of the help [F1] for details.
= Enter F1 = Help
= Scroll down F1 = Help
ESC
ESC
= Abort
= Abort