Electrical Connections - Jacuzzi LG72000 Installation Manual & Warranty Information

English
Subfloor
Prepare the subfloor for the drain and ensure that the area is level.
1. The drain/overflow of the bathtub extends below the bottom of the bathtub. The Technical Specifications can be found
at www.jacuzzi.com/baths/support/.
2. Make appropriate cuts to the subfloor to accommodate the drain.
3. The Jacuzzi Tru-Level® base is a standard feature on all bathtubs. If the subfloor is level and a continuous surface, no
other preparation is necessary. Proceed to the "Electrical Connections" section.
4. If the subfloor is not level, you must level the entire surface prior to installing the bathtub. The materials used will
insure that the bathtub is supported from the bottom. These materials include: leveling compound, mortar, plaster or
minimal expansion structural foam (having a density of a minimum 5 lbs/cubic foot). The bathtub must remain level in
order for it to drain properly and must make contact with the leveling material. Both sides of a joint or splice of subfloor
should be level to each other.
DANGER
: RISK OF ELECTRIC SHOCK!
circuit protected by a GFCI (Figure 3).
CAUTION!
Electrical outlet must be mounted 4" (101 mm) above the floor
line and 12" max (305 mm) inside from the edge of the bathtub (Figure 3), or in
accordance with local building and electrical codes.
CAUTION!
Risk of component overheat. Do not use electric extension
cord to power this unit. Operating the pump without enough water in the bathtub
can cause permanent damage to the pump/motor.
If the GFCI unit indicates a malfunction, per manufacturer's instructions, turn
OFF power and do not attempt to use the bathtub until the source of the problem
has been identified and corrected.
NOTES: When using electrical products, basic precautions should always be
followed. Always follow local building and electrical codes. Grounding is required.
The unit should be installed and grounded by a qualified electrician.
CANADIAN MODELS ONLY: The components must be hard wired in the
J-Boxes (supplied) that are located on the unit.
The Technical Specifications can be found at
www.jacuzzi.com/baths/support/.
Page 6
Framing and Support (

Electrical Connections

Connect only to a
www.jacuzzi.com
)
Continued
12˝
(305 mm)
4˝
(101 mm)
12˝
(305 mm)
4˝
(101 mm)
Installation
Shown: Pure Air®
Bath
Fig. 3
Shown: Whirlpool w/
optional heater