Advertisement
1.
Place the ANN-LC flat against the inside back wall of the FACP backbox. Position both bracket mounting tabs above
the two embossed protrusions in the backbox and slide the tabs down into the protrusions.
2.
Secure the mounting bracket to the backbox by installing the supplied self-tapping screw into the top embossed
protrusion/tab as illustrated below.
3.
Attach the grounding cable from the left corner of the mounting bracket to the backbox grounding stud, securing it
with hex nuts as illustrated below.
Note: When securing the ANN-LC
to ground, ensure that the ground
cable for the AC mains is installed
first, closest to the backbox.
IMPORTANT! Only 7 AH or 18 AH batteries will fit in front of the ANN-LC when installed inside the FACP backbox.
If 12 AH batteries are to be used, they must be installed vertically and sit on the left side of the bottom of the backbox.
2
Figure 1 Mounting the ANN-LC into the Backbox
grounding cable
(p/n 1120-0709)
secured with hex nuts
Figure 2 Securing the ANN-LC to the Backbox
ANN-LC Product Installation Document — P/N LS10158-000FL-E:C 7/28/2015
backbox
ANN-LC
protrusions
self-tapping
screw
Advertisement
