Parameter Settings Based On System Configuration - Lennox ComfortSense 8500 Series Installation And Setup Manual

Parameter Settings Based on System
Configuration
The first parameters (S-Bus Address) will always
need to be set. Available bus addresses are 1
through 31.
Other settings are available based on whether oper-
ations with smart hub and local scheduling functions
is set to ON or OFF.
Parameters
Display on home screen
Contractor info
Temperature sensor config.
Smooth setback recovery (SSR)
Offsets
Temperature adjustment range
Remember override set point
Schedule hold setting
Reminders
Reset to factory defaults
Change owner pin
RTU fan on/auto user control
Table 4. Parameter Settings based on System Configuration
The second and third parameter is operation with
smart hub and local scheduling.
That option is either ON or OFF for both. Default
is OFF for both. Available parameters settings are
dependent on whether either parameter is ON or
OFF. See the following table to determine available
parameters based on OFF or ON.
Setting Available when
Operation with Smart Hub is
ON or OFF
ON or OFF
ON or OFF
ON or OFF
OFF
ON or OFF
ON or OFF
OFF
OFF
OFF
ON or OFF
ON or OFF
ON or OFF
15
Setting Available when
Local Scheduling is set
to ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON
ON or OFF
ON or OFF
ON
ON
ON or OFF
ON or OFF
ON or OFF
ON or OFF