Advertisement
1. Fastening with screws
A) Insert a battery into battery compartment, press and hold the «Sound stop
/ Self-check» button for 1 second. Make sure that the red-yellow indicator is
flashing on the device, after which you will hear a corresponding beep;
B) Drill holes in the ceiling with a perforator;
C) Insert the dowels;
D) Using self-tapping screws, attach the mounting plate;
E) Attach the main alarm panel to the mounting panel in accordance with all the
index marks, scroll clockwise until you hear a click, that indicates fixation of the
device.
Using self-tapping screws, install the mounting plate.
Attach the main alarm panel to the mounting panel in accordance with all the
index marks.
Scroll clockwise until it clicks.
2. Mounting with adhesive tape
A) Insert a battery into the battery compartment, press and hold the «Sound
stop / Self-check» button for 1 second. Make sure that the red-yellow indicator is
flashing on the device, after which you will hear a corresponding beep;
B) Remove the protective film from one side of the adhesive tape and attach it to
the back of the mounting panel;
C) Remove the protective film from the other side of the adhesive tape and attach
Installation
the mounting plate to the ceiling;
D) Attach the main alarm panel to the mounting panel in accordance with all the
index marks, scroll clockwise until you hear a click, that indicates the fixation of
the device.
3. Precautions during installation
A) The device is only used indoors;
B) The distance between the device and the lighting equipment should be more
than 50 cm;
C) Do not install the device in a bathroom, in areas, where water easily enters;
D) Do not install near any heat sources or steam;
E) Do not install the unit in rooms with a temperature of -10 ° C and lower or 55 °
C or higher;
F) If the cabinet is sufficiently close to the ceiling, the distance between the
cabinet and the independent fire alarm should be 60 cm or more;
G) The distance between the device and the hood, the air conditioner and the
vent windows (openings) should be more than 150 cm;
H) It is recommended to install the device with screws. If you have chosen a
method, using adhesive tape, in the event of an unforeseen situation, the user is
solely responsible;
I) If you use the device mounting method, using adhesive tape, the selected
mounting surface must be smooth, flat, dry and clean;
J) If you have chosen a method using adhesive tape, it is necessary to regularly
check the reliability of fastening the device to avoid its falling;
K) If the battery leaks, you will not be able to install the device into the mounting
panel.
Advertisement
