Toro Groundsmaster 360 Series Operator's Manual page 9

located in the second row. This does not add 6
mm (1/4 inch) to the 15.8 cm (6 inch) position.
4. Adjust the anti-scalp rollers and skids as
required.
Adjusting the Skid(s)
Mount the skids in the lower position when operating
in height of cuts higher than 64 mm (2-1/2 inches) and
in the higher position when operating in height of cuts
lower than 64 mm (2-1/2 inches).
Note:
On Guardian ® mowers, when the skids become
worn, you can switch the skid to the opposite sides of
the cutting unit, flipping them over. This will allow you
to use the skids longer before replacing them.
1. Disengage the PTO and engagethe parking
brake.
2. Move the throttle lever to the S
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Loosen the screw at the front of each skid.
There are 2 skids on Guardian mowers and 1
skid on side-discharge cutting units
1. Screw
2. Flange-head bolt
4. Remove the flange-head bolts and nuts from
each skid.
5. Move each skid to the desired position and
secure them with the flange-head bolts and nuts.
Note:
Only use the top or center sets of holes
to adjust the skids. The bottom holes are used
when switching sides on a Guardian mower, at
which time they become the top holes on the
other side of the cutting unit.
6. Torque the screw at the front of each skid to 9 to
11 N-m (80 to 100 in-lb).
position,
LOW
(Figure
Figure 7
3. Skid
4. Nut
Adjusting the Rear Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the
height of the rear anti-scalp rollers.
1. Disengage the PTO, release the traction pedal,
and engage the parking brake.
2. Move the throttle lever to the S
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. After adjusting the height-of-cut, adjust the
rollers by removing the flange nut, bushing,
spacer, and bolt
7).
1. Flange nut
2. Bushing
3. Anti-scalp roller
4. Select a hole so the anti-scalp roller is positioned
g004479
to the nearest corresponding height-of-cut
desired (Figure
9
position,
LOW
(Figure 8).
Figure 8
4. Spacer
5. Bolt
9).
g004483