Installation Procedure; Prepare Installation Space; Install The Cooktop - Bosch NGM8657UC Installation Manual

Installation Procedure

Prepare Installation Space

Create the cut-out in the countertop according to the
installation drawings. The angle of the cut surface to the
countertop must be 90°.
After creating the cut-out, remove shavings. Seal cut
surfaces in a heat-resistant manner.
Some solid surface countertops require special
installations. For example, heat reflective tape and
rounded corners may be necessary. Contact the
countertop manufacturer for instructions specific to your
countertop.
WARNING
9
To avoid electrical shock hazard, before installing
the cooktop, switch power off at the service panel to
prevent the power from being switched on
accidentally.
Cut out the countertop per the dimensions shown in the
section "Countertop Requirements".
If there is no oven beneath the cooktop, put a non-
flammable intermediate floor (e.g. metal or plywood)
(10 mm) from the base of the cooktop. This will prevent
access to the base of the cooktop.
The distance from the intermediate floor to the power
supply connection for the appliance must be at least
(10 mm).

Install the Cooktop

WARNING
9
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the OFF
position.
CAUTION
9
Sharp edges. Use protective gloves when installing
the cooktop.
IMPORTANT: A foam tape seal is factory installed on the
underside of the cooktop to prevent leaks. Do not
remove the seal under any circumstances.
8
I n s t a l l a t i o n P r o c e d u r e
P r e p a r e I n s t a l l a t i o n S p a c e
/ "
3
8
/ "
3
8
Screw each one of the clips into the position shown in
1.
the following image, so that they are free to rotate.
Turn the mounting brackets and tighten them fully. The
2.
orientation of the mounting brackets depends on how
thick the countertop surface is.
For countertops between 2" (50 mm) and 2¾"
(70 mm) thick, insert a wooden block between the end
of the adjusting screw and the bottom of the
countertop.
Note: Do not overtighten adjusting screw.