Setting Up Instant Mymedia; Setting Up/Skipping Channels Setting Up Channels; Skipping Channels - Fujitsu LifeBook N Series Manual

SETTING UP INSTANT
MYMEDIA
When using Instant MyMedia for the first time,
setup will begin automatically after Instant
MyMedia is activated. Follow the steps below to
complete installation.
When performing the installation, do not wear
headphones initially; the volume may be
greater than expected.
Be sure to follow the steps indicated below.
Attempting to install Instant MyMedia using
different steps could result in failure to start.
If Instant MyMedia fails to start after following
these steps, refer to the Troubleshooting
section of this manual.
1. Verify that the system is not powered on, then
press the MyMedia button on the remote
control. During the first por tion of the
installation, the notebook will cycle through
several screens as different portions of the
installation take place. At the end of this
portion, the notebook will turn off.
2. Verify that the power indicator is not lit.
3. Press the MyMedia button on the remote
control again. The Instant MyMedia main
menu will appear. Instant MyMedia is now
ready to use.
36
SETTING UP/SKIPPING
CHANNELS
Setting Up Channels
1. Press the MyMedia button on the remote
control to display the main menu.
2. If it's not already selected, select TV with the
cursor buttons, then press the [Enter] button
on the remote control. Instant MyMedia enters
TV mode.
3. Press the [Menu] button to display the menu.
4. Select Antenna or Cable, depending upon
how your tuner is connected. Press [Enter].
5. In the left hand panel, select Favorite Channel
List. To automatically assign a broadcast
station to unassigned channels, set the
selection to On.
6. Select Auto Scan with the cursor buttons,
select Run, then press [Enter].
7. A channel search will begin. During the
channel search, channels are switched one
after another; this could take some time. Each
time a channel search is performed, different
channels may be detected due to changing
reception conditions.

Skipping Channels

You can determine which detected channels are
displayed and which are skipped using the
remote control or the channel button on the
notebook.
1. Press the Menu button to display the menu
and select TV Channel using the Cursor Move
buttons.
2. Press the right-cursor move button to enter
the list of channels. Select a channel and
press the [Enter] button. Channels with a circle
to the left are the channels that are set; they
will not be skipped.
3. If you want to skip a detected channel, select
the channel you want to skip and press the
[Enter] button. The circle will disappear,
indicating that the channel will be skipped.