Advertisement
Component & Control Testing Procedures
To avoid risk of electrical shock, personal injury or death; disconnect power to range before servicing, unless
testing requires power.
Illustration
Ribbon element,
(Series 12)
warming, 100 W
Temperature sensor
Control
Oven temperature
H1
adjustment
Temperature display
H1
Clock display
H1
24-hour clock
H1
Factory default
H1
12-hour shutoff
H1
Sabbath mode
H1
Child lockout
H1
Diagnostic code display
H1
16027229
Replaces 16026900
!
Component
Disconnect wiring to element and measure
cold resistance of terminals ...........................
Measure voltage at element...........................
Disconnect wire leads to sensor and
measure resistance ....................................... Approximately 1080 Ω at room
Feature
Press BAKE pad.
Enter 550 on the digit pad.
Immediately press and hold BAKE pad for 3
to 5 seconds.
Oven can be adjusted from -35 to +35
degrees in 5-degree increments by pressing
AUTOSET pads. To avoid over adjusting the
oven, move temperature 5 degrees each
time. Wait 4 seconds for the data entry timer
to expire to accept the change. Temperature
adjustment will be retained even through a
power failure.
Press and hold CANCEL and BAKE pads
for 3 to 5 seconds.
Press and hold CANCEL and CLOCK pads
for 3 to 5 seconds.
Press and hold CANCEL and FAVORITE
pads for 3 to 5 seconds.
Press and hold CANCEL and KEEP WARM
pads for 3 to 5 seconds.
Control cancels cooking operations and
disables relay drives 12 hours after last pad
touch.
Hold CLOCK pad for 3 to 5 seconds to
activate Sabbath mode.
Hold CLOCK pad for 3 to 5 seconds to
disable Sabbath mode.
Desired bake function must be initiated
before entering Sabbath mode.
Press and hold CANCEL and COOK &
HOLD pads for 3 to 5 seconds. "OFF"
displays in temperature display area.
"LOCK" flashes while door is locking.
To reactivate control, press and hold
CANCEL and COOK & HOLD pads for 3 to
5 seconds.
Press and hold AUTOSET pad when
applying power to the range.
Cycle through the codes using the number
pads 1 through 5.
WARNING
Test Procedure
Procedure
4
Results
Approx. 141 to 155 Ω.
240 VAC. If voltage is not present,
check wiring.
temperature 80° F.
Results
Increasing or decreasing oven
temperature does not affect self-
cleaning temperature.
Allows user to change
temperature display between
°F or °C.
Allows user to turn clock display
on or off.
Allows user to toggle clock
display between 12-hour or
24-hour format.
Allows user to reset clock to
factory settings.
See Sabbath mode to disable.
"SAb" flashes for 5 seconds,
then remains on until timed-out
or canceled. (Status SAb is not
fault code 5A6.) All pad inputs
are disabled except CANCEL
and CLOCK. 12-hour shutoff is
disabled, allowing bake mode
operation for 72 hours. The oven
light is not disabled.
This safety feature prevents
children from accidentally
programming the oven. The
electronic oven control is
disabled.
Child lockout features must be
reset after a power failure.
The last 5 diagnostic codes will
be stored in the non-volatile
memory.
See "Description of Error
Codes" for explanation.
June 2006
© 2006 Maytag Services
Advertisement
