Preparing For The Installation Of The Tv; Confirming The Completion Of The Installation; Installing The Tv On The Wall; Other Information - Sony SU-WL450 Operating Instructions Manual

3
Fit Base Adaptor  by using
Screw (PSW 4x10)  to Base
(20)  when selecting 2-a.
Refer to Installation Guide, 3
and "Installing the TV to the
wall" of TV's instruction manual.
In case of selecting 2-b, then
skip this step.
4
Decide the positions of the
screws for installing the Base
(20) .
Refer to the specifications on page 6.
When selecting 2-a, please use the hole
positions of Base Adaptor .
WARNING
ˎ The wall that the TV will be mounted on should be
able to support a weight of at least four times that of
the TV (Refer to your TV's operating instructions for
its weight.).
ˎ Determine the strength of the wall the TV will be
mounted on. Reinforce the wall sufficiently, if
necessary.
Installing the Base on the
wall
ˎ Use four or more screws of 8 mm diameter
or equivalent (not supplied).
ˎ Fit four screws to the holes of Base
Adaptor  With Base (20)  (2-a only).
ˎ Install the Base (20)  on the wall
horizontally.
Refer to the "Installation Guide", 4.
Preparing for the installation
of the TV
Prepare installation of the TV, following the
"Installing the TV to the wall" of TV's
instruction manual.

Installing the TV on the wall

1
Connect the necessary cable(s)
to the TV.
Make sure to connect the cables before
installing the TV on the wall. You will be
unable to connect the cables when the TV
is installed.
Refer to the operating instructions
supplied with your TV.
Note
ˎ Subcontract the cable routing in the wall to a licensed
contractor.
ˎ Bundle the connecting cables to prevent stepping on
them before wall mounting.
2
Install the TV onto the Base.
ˎ For the location of the Pulleys  to the
hang on the Base, refer to the TV
installation dimensions table. For details,
refer to the TV's instruction manual.
ˎ Hold the TV securely with both hands
and gently hang the Pulleys  attached
to the rear of the TV to the Base, making
sure to confirm the shape of the holes.
ˎ After installing the TV on the wall,
confirm the Pulleys  are firmly latched
into the Base.
Refer to the "Installation Guide", 5.
WARNING
ˎ Be sure that two or more persons hold the TV when
carrying it.
3
Preventing the bottom of the TV
from shifting.
ˎ Take up the slack of Belt  and attach it
to the wall tightly.
Refer to the "Installation Guide", 6.
ˎ Use a 5 mm diameter screw or
equivalent (not supplied).
Note
ˎ Try to pull the bottom of the TV forwards yourself
slightly, to make sure that it does not move forward.
If there is any movement, it is not fixed correctly, and
the Belt  should be secured firmly again.
Confirming the completion of
the installation
Check the following points.
ˎ The Pulleys  are firmly hung onto the
Base.
ˎ The cord and the cable are not twisted or
pinched.
ˎ The Belt  is tight with no slack.
WARNING
ˎ Improper placement of the AC power cord, etc., may
cause fire or electric shock through a short circuit. Be sure
to confirm the completion of the installation for safety.

Other information

When removing the TV, reverse the previous
installation procedure.
Refer to the "Installation Guide", 7.
WARNING
ˎ Be sure that two or more persons hold the TV when
removing it.
GB
GB
5