Routing With The Dante Controller - Monacor IT-400DT Instruction Manual

4.3 Routing with the Dante Controller

To assign the input signals and output signals of the corresponding
units:
1) Under "Routing" in the window "Network View", click
the transmitting channels of the desired Dante transmitter under
"Dante Transmitters" and the receiving channels of IT-400DT under
"Dante Receivers" (
2) Navigate from the column of the Dante transmit channel to the
row of the desired Dante receive channel of IT-400DT and click the
field at the intersection point .
3) Wait for the field to show a green circle with a white check mark ✔ .
4) Repeat the last two steps for the second Dante receive channel of
IT-400DT, if required .
38
☞
fig . 3) .
⊞
to open
Fig. 3 Audio routing from the audio source "DADC-144DT"
to the receiver "IT-400DT"
An English user guide for the Dante Controller is available for down-
load on the Audinate website:
https://www .audinate .com/resources/technical-documentation