Panasonic WJ-FS216 Service Manual page 5

13. Recording Output Connector (REC OUT)
This connector supplies the recording signal for the time
lapse VTR.
Caution:
In MULTIPLEX mode, the unit adds codes to video
signals during vertical blanking while they are
recorded on the VTR. This is the reason why video
signals with a certain code are not recordable during
vertical blanking.
14. Monitor Output Connector (MONITOR OUT)
This connector supplies a composite video signal for
monitoring. Sequential picture, time lapse VTR playback
pictures and the menus can be displayed on a connect-
ed monitor.
15. Camera Switching Signal Input Connector
(CAMERA SW IN)
The camera switching signal from the time lapse VTR is
supplied to this connector. This connector works only
when the MULTIPLEX mode is selected.
Note:
When REC MODE is set to T/L but no camera
switching signal is supplied, time lapse recording will
not work properly.
16. ALARM/REMOTE Connector
This connector is used for remote controlling. You can
control the following functions:
• Alarm Output
• Recover Input
• MULTISCREEN
• SEQ
• Receiving the alarm input signal at the camera site,
or the remote input signal for the camera selection
buttons.
17. Ground Terminal
18. Power Cord
RACK MOUNTING
To install the WJ-FS216 Video Multiplexer in an EIA 19-inch
rack, use the rack mounting brackets (provided) and eight
screws (provided, M3x10).
1. Turn off the power of the unit.
2. Remove the four screws fixing the rubber legs and
remove the four rubber legs from the unit.
3. Attach the rack mounting brackets on both sides and fix
them with eight screws (provided).
Fix the rack mounting brackets
4. Install the unit in the rack with four screws (to be pro-
cured locally).
EIA 19"
rack
Cautions:
1. Leave one space free both above and below the unit, or
install a cooling fan in the rack.
2. If the rack is subject to vibrations, secure the rear of the
unit to the rack using additional rack mounting brackets
(to be procured locally).
3
Remove four rubber legs.
Eight screws (Provided)